Perform testing, troubleshooting, rework and assembly of electrical subassemblies, power supplies and control modules for Mevion products
Job duties and responsibilities:
- Tests simple to complex electronic and electro-mechanical subassemblies, power supplies and control modules using standard hand-held and automated test equipment. Troubleshoot issues and collaborate with manufacturing engineers to find resolution.
- Sets up and performs bench, component, and system level tests.
- Performs set-ups for AC and DC digital tests.
- Adjusts or replaces defective or improperly functioning circuitry or electronic components using hand tools or soldering iron.
- Provides controlled documentation of component alterations to update as-built drawings and diagrams.
- Disassembly, rework, and re-assembly of electronic assemblies and subassemblies. Assists with creation of written test procedures for new assemblies
- Provide engineering support or recommendations for new or existing equipment with regard to installation, upgrades, or enhancements.
- Installs completed electrical assemblies into equipment cabinets.
- May perform preventative maintenance and/or monitor calibration of equipment to ensure equipment is properly calibrated prior to use.
- Specifies and assists in acquisition of tools and equipment.
- May assist with Production assembly work at Production Supervisor’s discretion.
- Helps prepare systems for shipment.
- Participate in general clean up and maintenance on production floor as required.
Education and Experience:
- Associate’s degree in electronics or equivalent plus. 5-7 years of experience in electrical test and repair experience in the technology or medical device industry.
- Ability to troubleshoot and analyze failures using electronic test equipment and software.
- Ability to operate digital volt meters, AC test fixtures, power supplies, etc.
- Strong attention to detail and the ability to work from written test instructions is required.
- Proficient at reading blueprints, wiring diagrams, schematic drawings, or written work instructions for assembling electronic units.
- Working knowledge of electronic theory and components.
- Soldering proficiency for both mechanical joints and electrical connections.
- Experience with controlled documentation and FDA compliance is desired.
- Experience with accelerator systems (RF, high power electronics, high vacuum, superconducting magnets) is helpful.
- Ability to utilize a computer for documentation and testing. Ability to use a keyboard and utilize Microsoft office products is helpful.
- Environment requires the use of 120, 208 and 480 VAC and 24V and 1000 VDC
- Position requires sitting 5-6 hours per day
- May require occasional travel to customer sites in the event of an emergency.
This position is located in Littleton, Ma
Submit your resume to email@example.com